[vc_row full_width=”stretch_row_content_no_spaces” content_placement=”top” css=”.vc_custom_1481317372265{margin-top: -145px !important;}”][vc_column][vc_single_image image=”10656″ img_size=”full”][/vc_column][/vc_row][vc_row][vc_column width=”5/12″][vc_single_image image=”9846″ img_size=”full”][vc_column_text]

Robbialac Heat Resisting Aluminium Paint

[/vc_column_text][/vc_column][vc_column width=”7/12″][vc_tta_tabs][vc_tta_section title=”Designed use” tab_id=”1484264231178-44c38498-5ffc”][vc_column_text]Product description

Aluminium Paint H.R. is a heat resistant paint base, on an air drying, Styrene modified oil.

 

Recommended use

On steel items exposed to temperature up to 250°C, e.g.exhaust pipes engine parts etc. Can be used as an exterior aluminium finish usually within an alkyd system.

 

Film thickness and spreading rate

Minimum                     Maximum                Typical

Film thickness, dry (µm)                                         20                                  30                          25

Film thickness, wet (µm)                                        45                                   65                         55

Theoretical spreading rate (m3/l)                        22.5                                15                         18[/vc_column_text][/vc_tta_section][vc_tta_section title=”Surface preparation” tab_id=”1484264231179-51cbde1e-96ec”][vc_column_text]Surface preparation

All surfaces should be clean, dry and free from contamination. The surface could be assessed and treated in accordance with ISO 8504.

 

Bare steel

Cleanliness: Blast cleaning to Sa 2½ (ISO 8501-1:2007) Roughness using abrasive suitable to achieve grade find to medium G 930-85 um, Ry5) (ISO 8503-2)

 

Other surfaces

The coating may be used on other substrates. Please contact your Berger international office for more information.[/vc_column_text][/vc_tta_section][vc_tta_section title=”Method of application” tab_id=”1484264285516-302f5b9f-f880″][vc_column_text]Condition during application

The temperature of the substrate should be minimum 3°C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate. Good ventilation is usually required in confined areas to ensure correct drying.

Application methods

Spray   : –     Use airless spray or conventional spray

Brush   : –     Recommended for stripe coating and small areas ,care must be taken to achieve the

Specified dry film thickness

Roller   : –   May be use for small areas but not recommended for first primer coat. However when using

Roller application care must be taken to apply sufficient material order to achieve the

Specified dry film thickness.[/vc_column_text][/vc_tta_section][/vc_tta_tabs][/vc_column][/vc_row]